Kenmore 253 Manual De Instrucciones página 13

FREEZER DOOR:
1+ Remove the toe grille (see "Outside" in Care and
Cleaning Section).
2+ To disconnect water line, grip tube firmly in left hand and
use tool (located in bag under toe grille) to push in on
gray collar to release water connector (Figure 1)o
Figure 2
3+ Remove screw to detach lowerhinge cover (Figure 2)+
4+ To disconnect wiring harness plug connector, place your
thumbs on the flat sides of each connector piece° Bend
both parts back and forth. Then with a firm grasp, pull
the two pieces apart as shown (Figure 3).
5. Place a strip of tape along door bottom, over lower
hinge and up the side of the door. This will hold hinge in
ptace when door is removed (Figure 4).
Figure4
6+ Loosen, but DO NOT REMOVE, bottom lower hinge
bolt. Remove top lower hinge bolt (Figure 4),
7+ Remove top hinge cover by liftingback of cover and
sliding forward. Remove screws mounting hinge
bracket to cabinet. Hold bracket when removing last
screw; door closer mechanism places mild springtension
on hinge+DO NOT remove hinge bracket from door,
8. Carefully lift door up and off loosened lower hinge bolt
(Figure4)+
REFRIGERATOR DOOR:
1+ Remove top hinge cover by lifting back of cover and
sliding forward, Remove screws mounting hinge
bracket to cabinet. Hold bracket when removing last
screw; door closer mechanism places mild spring tension
on hinge+DO NOT remove hinge bracket from door,
Loosen, but DO NOT REMOVE, bottom lower hinge
bolt. Remove top lower hinge bolt
3. Carefully lift door up and off loosened lower hinge bolto
Store doors in a safe place until refrigerator is moved to
desired location. Keep all hardware for reinstallation.
.
TO REINSTALL FREEZER DOOR:
+
2+
3_
Position door on unit and tighten screws_
Reconnect the wiring connector, making sure it is locked.
Fold wires as shown and apply a twist tie (Figure 2).
insert tube through hole in cover_ Position cover over
wires without pinching the wires. Install the screw to
attach cover.
IMPORTANT:To reinstall water fine connector, push door
tube firmly into connector until connector touches the
black mark on the tube and stops (Figure 5). This
step is critical to ensure that the water line does not leak+
Water Une
Gray Connector Ink--7
o!_ar Mark/
Tubing Water
from Door Line
Figure 5
TO REINSTALL REFRIGERATOR DOOR
To reinstallrefrigerator door, reverse instructions used to
remove door
13