Idiomas disponibles
Idiomas disponibles
(2) Trigger switch (Fig. 17)
This tool is equipped with a variable speed controlled
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger. The
blade plunger stroke rate can be adjusted from the
minimum to maximum nameplate stroke rate by
the pressure you apply to the trigger. Apply more
pressure to increase the speed and release pressure
to decrease speed.
Trigger switch
Stroke Mode
Trajectory of Motion
Hardness of Material
Cutting Speed
Level of Finish
NOTE
○ To select the stroke mode, operate the change lever when the product is completely stopped.
○ Select Straight Mode if you wish to cut soft materials neatly.
○ Occasionally clean the change lever as its movement may be adversely aff ected if dirt or dust collects on the
change lever.
Change Lever
(Straight Mode)
Fig. 17
Straight mode
Back and forth action
Hard material
Slow
Smooth
2. Stroke Mode
This power tool features a straight mode in which the
blade moves back and forth, and an orbital mode in
which the blade moves back and forth while moving
up and down.
For soft materials such as wood, orbital mode
ensures smooth cutting operation while improving the
discharge of sawdust and the interlock with materials.
Use the change lever to select the ideal mode for the
task at hand. (Fig. 18)
The ideal mode depends on factors such as the
hardness of the material to be cut and the level of
fi nish required. Use Table 5 as a guideline when
making your choice.
Table 5
Back and forth action + up and down action
Fig. 18
English
Orbital mode
Soft material
Fast
Rough
Change Lever
(Orbital Mode)
15
