Idiomas disponibles
Idiomas disponibles
English
CAUTION
● When the battery charger has been continuously
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
● If the battery is charged while it is heated
because it has been left for a long time in a
location subject to direct sunlight or because
the battery has just been used, the pilot lamp of
the charger lights for 1 second, does not light for
0.5 seconds (off for 0.5 seconds).
The battery will not be recharged. In such a
case, let the battery cool before charging.
● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger's battery connector. If
there are no foreign objects, it is probable that
the battery or charger is malfunctioning. Take it
to your authorized Service Center.
BEFORE USE
WARNING
In the following situations, press in the lock-off
button to the Lock side (right side).
○ When stopping or ending work
○ When attaching or removing the blade
○ When adjusting the position of the base
○ When removing or attaching the battery
○ When selecting the stroke mode
For how to use the lock-off button, see "(1) Lock-off
button" in "1. Switch operation" on page 14.
PRIOR TO OPERATION
WARNING
To avoid serious accident, ensure the switch is
in the OFF position, and pull out the battery.
1. Check the work area environment
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
2. Power switch
Ensure that the switch is in the OFF position.
3. Mounting the blade
This unit employs a detachable mechanism that
enables mounting and removal of saw blades without
the use of a wrench or other tools.
(1) Pivot the blade holder to open the blade clamp.
(2) Insert the saw blade all the way into the slit of the
blade holder with the blade holder pivoting.
12
(3) When you release your hand from the blade holder,
the blade is fi xed in place.
Blade holder
Slit of blade holder
Blade
You can mount this blade either in the upward or
downward direction. (Fig. 8)
Slit of blade holder
Blade mounted in
upward direction
(4) Pull the back of the saw blade two or three times by
hand and check that the blade is securely mounted.
(Fig. 9)
Blade
CAUTION
When pulling the saw blade, be absolutely sure
to pull it from the back. Pulling other parts of the
blade will result in an injury.
Fig. 7
Fig. 8
Fig. 9
