Teac A-3300SX Manual Del Usuario página 22

Tape deck estereo
| 'Playback
Compatibility. 'and
_
Setting | me Pleyback. Level
Playback Compatibility
A 4 track stereo tape deck can playback both 4 track and 2
track
tapes
and
from
the
standpoint
of compatibility
has the widest possible range of utilization. When playing
a 2 track stereo tape on a 4 track deck, track #1 will be
completely covered by the head. Track #2 will be slightly
off alignment but stereo can still be enjoyed by compen-
sating for the slight loss of track #2 volume with the
Volume
or balance controls. On the other hand a 4 track
tape cannot be played back on a 2 track deck as both tracks
#1 and #2 will be reproduced together resulting in mixed,
unintelligible sound. See Fig.
A which shows the standard
NAB track configurations for 2 track and 4 track recording.
2,030
05
6.20
9640.10
ik
|
6.254
0.05
"2" TRACK
"4" TRACK
(NAB)
Fig. A
Setting the Playback Level
The OUTPUT
Level Controls regulate the audio level to
your
stereo amplifier and also the listening level to your
headphones, allowing you to monitor the level and quality
of the sound fed to the amplifier. When listening through
an amplifier, it is best to have the deck's output approxi-
mately the same as the original recording level.
1, Set the OUTPUT Selector Switches to TAPE.
2. Set the OUTPUT
Level Controls to approximately the
2 o'clock position.
3. Begin playback by depressing the » Button.
4, Adjust the OUTPUT
Level Controls so that the loudest
passages on the tape indicate about 0 VU,
. Make all listening volume adjustments (for foud speaker
output) by changing the volume controls on the stereo
amplifier,
6. Further changes to the OUTPUT
Level Controls are not
needed
unless
the
VU
Meter
pointers greatly exceed
OVU.
ol
299
5 Wiedergabe-Kompatibilitat 'ond.
Wiedergabe-Kompatibilitat
Aussteuerung des Wiedergabepegels
Verstarker
zugefiihrten
als auch
den
im
Kopfh6rer
zu
hOrenden
Signalpegel,
der
ihnen
damit
eine
Qualitits-
moglicht.
Wenn
Sie die Wiedergabe
iiber den
Verstarker
auszusteuern.
1. Ausgangswahlschalter auf TAPE stellen.
3. Wiedergabe
durch
Driicken der Wiedergabetaste
( >» )
starten.
,
Aussteverung des Wiedergabepegels - a.
loading