Idiomas disponibles
Idiomas disponibles
Next, position it on the "U" at the
bottom of the left focus bar (13L),
Fig.6B.
Insert screw (15), as shown in Fig.6B,
then fit the flat washer (8) and the self
locking nut (16), and tighten securely.
Take the right foot bar (83) and go
through the same assembly procedure
as with the left.
Then fit the trim covers (14R & 14L),
using screws (79) to secure them,
Fig.6D.
5. FITTING THE FOOTRESTS.-
Position the left footrest (23L) (marked
with the letter "L") on top of the unit's
left foot (21), Fig.7, (left and right
refers to the user's position doing
exercise) refit the screws (22), the
washers (8) and the nuts (4) removed
previously and tighten securely.
Next, position the right footrest (23R)
(marked with the letter "R") on top of
the right foot (83), refit the screws
(22), the washers (8) and the nuts (4)
removed
previously
securely.
6.- FITTING THE MONITOR
SUPPORT.-
Plug connector (93), coming out of the
main post, into connector (80), coming
out of the boss (64) on the main body
(72), Fig.8.
Slip the main post (64) over the boss
(72) on the main body in the direction
of the arrow, Fig.8, making sure not to
snag any of the cables.
Take the front (70R) and rear (70L)
covers and position them on the
main post (72), Fig.8. Now use the
screws (79) to attach them to the
post.
and
tighten
16
7 FITTING THE UPPER
FOCUS BARS.-
Take the top left bar (3L) (marked with
the letter "L").
Insert the top bar onto the bottom left
focus bar (13L), lining up the letters
(L), Fig.9, fit the screws (6), and the
cap nuts (4) and tighten securely.
Now go through the same procedure
for the top right focus bar (3R).
8. FITTING THE FOCUS BAR
SIDE COVERS.-
Take the covers (11L and 11R),
marked on the inside with the letter
"R", and position them at the spindle
end with the bars on the right hand
side, as shown in Fig.9. Now use
screws (12) to attach them.
Carry out the same procedure at the
other end of the bar using the covers
(11L and 11R) marked on the inside
with the letter "L".
9. FITTING THE ELECTRONIC
MONITOR.-
ATTACHING THE MONITOR.
Release screws (69), Fig.10, at the
back of the monitor (63).
Then connect terminals (93 & 93a).
The handgrip terminals (41a with 41)
and (42a with 42), Fig.10.
Next, slide the front of the monitor
onto the plate on top of the main post
(64) in the direction of the arrow,
Fig.10, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(69) removed previously.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level.
