Intended Use; Technical Data - Bosch GLL2-45 Instrucciones De Funcionamiento Y Seguridad

The tool is intended for determining and checking horizontal and vertical lines.
Inserting/Replacing the Battery
Use only alkaline batteries.
To open the battery lid 8, press the latch of
the battery lid 11 in the direction of the arrow
and remove the battery lid. Insert the supplied
batteries.
When inserting, pay attention to the correct
polarity according to the representation on the
inside of the battery compartment.
The numbering of the product features shown
refers to the illustration of the tool on the
graphic page.
1 Exit opening for laser beam
2 Pulse-function indicator
3 Pulse-function button
4 Operating mode button
5 Battery indication
6 Tripod mount 1/4"
7 On/Off switch
8 Battery lid
9 Serial number
Working range
– Standard ....................................... 65 ft (20 m)
– With laser receiver ....................... 150 ft (45 m)
Levelling Accuracy:
Minimum Factory Accuracy ..............±00.012in/ft
Typical Accuracy ....................up to 1/4" at 100 ft
Self-levelling range, typically ..........................±4°
Levelling duration, typically ........................... <4s
Operating temperature .....................14° F 122° F
Storage temperature .........................-4° F 158° F
Relative air humidity, max ........................... 90 %
Laser class ....................................................... 2

Intended Use

Preparation
When the battery indication 5 flashes red, the
batteries must be replaced.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
it for extended periods. When storing for
extended periods, the batteries can corrode and
discharge themselves.
Features
*The accessories illustrated or described are
not included as standard delivery.

Technical Data

Laser type ................................. 635 nm, <1mW
C6 >............................................................ 3.33
Tripod mount............................................1/4-20
Batteries ................................ 3 x 1.5 V LR6 (AA)
Operating lifetime, approx ........................... 12 h
(±0.3 mm/m)
Automatic switch-off after approx. ...........30 min
Weight according to EPTA-Procedure
(6 mm at 30 m)
01/2003 ...........................................1lb (0.45kg)
Dimensions .................... 4-5/8" x 2-1/4" x 3-1/2"
Degree of protection .................................. IP 54
(–10° C +50° C)
(dust and splash water protected)
Please observe the article number on the
(–20°C +70° C)
type plate of your tool. The trade names of the
individual tools may vary.
The tool can be clearly identified with the serial
number 9 on the type plate.
-8-
Remove the batteries from
!
WARNING
the tool when not using
10 Laser warning label
11 Latch of battery lid
12 Belt Pouch
13 Positioning Device
14 Laser viewing glasses*
15 Measurement plate with stand
16 Laser Receiver*
17 Telescoping Pole System*
18 Tripod*
(118 x 57 x 89mm)