Removing/Installing The Lower Plate - Panasonic QUICKDRAW MC-V5247 Instrucciones De Operación

A WAR NIN G Electric Shock or Personal injury Hazard.
When the lower plate is removed for any reason, before reinstalling, be sure that all elec-
trical wires are routed in a manner that prevents them from coming into contact with the
lower plate, lower plate screws, or any moving parts. Be sure that the wires are not
pinched in any way when the lower plate is reinstalled.
ct the
vacuum cleaner from the electrical outlet.
Replacing some of the parts in this section involves the
removal and installation of the lower plate. Always
place paper under nozzle anytime the lower plate is ES)
removed to protect the floor surface. 228
To Remove Lower Plate.
Start by placing the handle in the upright position, See the Lower
HANDLE ADJUSTMENTS section. Turn the vacuum cleaner Plate <>
over, exposing the underside. Release the lower plate by
pressing the two (2) latches that secure the lower plate inward, as shown in the
illustration. Remove the tower plate and remove any residue that may exist in the belt area.
To Reinstall Lower Plate.
Close the rear belt cover. Hook the front end of lower plate onto the tabs on the front of the noz-
zle housing. Press the lower plate into place and fasten by pushing the two (2) latches outward.
NOTE: To ensure maximum cleaning efficiency, the belt should be checked regularly to make
sure it is in good condition. Check to see if the belt is stretched, cracked, or if excessive slippage
has occurred. Replace if necessary.
NS vá se
1. Remove the lower plate using the procedure in
the REMOVING/INSTALLING THE LOWER PLATE
section.
2. Remove the bulb socket screw, grasp the bulb
socket, wiggle the socket back and forth while
pulling it up out of the nozzle housing. To remove Ё | t
the old bulb, push it in toward the bulb socket while f
turning counterclockwise, then remove. { |
3. Install the new bulb by pushing it in toward the A us — tha)
bulb socket and turning it clockwise. Use any stan- M E nel CI Img p осир
dard bayonet base appliance bulb rated at 130 Bulb Socket Assembly
Volts AC/15 Watts.
NOTE: Do not use a bulb rated over 130 Volts AC/15 Watts. During extended use, heat from the
bulb could overheat the surrounding plastic parts.
4. Reinsert the bulb socket Into the nozzle housing by pushing it back down Into the slot and
replace the bulb socket screw. Replace the lower plate as outlined in the
REMOVING/INSTALLING THE LOWER PLATE section.