Autoadapt Turny Low Vehicle Manual De Instalación página 22

22
Turny Low Vehicle Getting seated
Installation
1. Route and install cables in the car
Route and install cables for the hand-held control, door switch, earth and 12V. The
illustration below shows the associated connection points in the unit.
For a complete wiring diagram, see the back of the manual.
A / Options
- optional feature
B / Lower seat belt attachment
- is connected later
C / Belt buckle
- is connected later
C
B
A
2. Install the bracket in the car
A bracket is necessary between the product and the floor of the car to install Turny
Low Vehicle. We recommend a car-specific model. In cases where a car-specific
bracket is lacking, a universal bracket is available. For the full bracket range, see,
dealerweb.autoadapt.com
To install the bracket, follow the relevant instructions enclosed with the bracket.
Hand-held control
The small magnet is for hanging up the hand-
held control. Position in a suitable place in the
car's panel and tightly screw from the back.
Door switch
Black cable
Adjust the length of cable and connect to
the negative terminal of the car battery.
Red cable 12V
Adjust the length of cable and connect to
the positive terminal of the car battery. Plug
in supplied fuse in close proximity to the car
battery.