Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ttOW TO USE
cUSTOM PROGRAM
If you have a special combination
of settings
that
you use frequently,
you can save these
settings
as a CUSTOM
PROGRAM.
TO Save a Custom
Program:
O
Turn on the dryer and turn the cycle
selector
knob to select the desired
cycle.
tUse
the cycle
setting
buttons
to adjust
the
settings
for that cycle.
O
ress the cycle option
button(s)
for the option
you would
like to add. A confirmation
message
will be shown
in the display.
Press and hold the CUSTOM
PROGRAM
button
for 3 seconds.
STEAM FUNCTIONS
TO Fill the
Steam
Feeder
Pull out the drawer.
Li_ out the steam feeder.
NOTE: You may only save one custom
program at a time. Pressing and holding the
CUSTOM PROGRAM button will overwrite
any previously saved custom program.
TO Recall
a Custom
Program:
Turn on the dryer.
O
Press the CUSTOM PROGRAM button.
O
Press the START/PAUSE button to start
the cycle.
O
Fill the steam feeder
to MAX with water.
f
Water
_
.................
_'_
ONLY
\
Steam
_
t "",,,_44_'_
;
Feeder
(-"", _,_l
k
"_"_W
\.
O
Place the steam feeder
in the drawer;
then
push in the drawer
until it clicks
into place.
52
iMPORTANT
NOTES
ABOUT
STEAM
CYCLES
Before using a Steam Cycle, the steam feeder must be filled with water up to the MAX line. If not, the ADD
WATER light will blink. Make sure that the steam feeder is filled with water and the drawer is completely
closed. Turn the dryer off then restart the Steam Cycle.
• Only use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is empty.
• Do not use distilled water; the water level sensor in the steam generator will not work.
• Be careful to put the Steam Feeder otherwise water will be overflow.
• Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
, WARN|NG:
= Do not fill the steam feeder with liquids such as gasoline, dry-cleaning
solvents, or other flammable or explosive
substances.
They give off vapors that could explode.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
• Do not drink water from the steam feeder.
Capítulos
Tabla de contenido
