Custom Program; Steam Functions - LG DLEX3570 Serie Manual Del Propietário

36
HOW TO USE

Custom program

If you have a special combination of settings that you
use frequently, you can save these settings as a CUSTOM
PROGRAM.
To Save a Custom Program:
1. Turn on the dryer and turn the cycle selector knob to
select the desired cycle.
2. Use the cycle setting buttons to adjust the settings for
that cycle.
3. Press the cycle option button(s) for the option you
would like to add. A confirmation message will be
shown in the display.
4. Press and hold the CUSTOM PROGRAM button for 3
seconds.
NOTE
You may save only one custom program at a time.
Pressing and holding the CUSTOM PROGRAM button
will overwrite any previously saved custom program.
To Recall a Custom Program:
1. Turn on the dryer.
2. Press the CUSTOM PROGRAM button.
3. Press the START/PAUSE button to start the cycle.

Steam functions

To Fill the Steam Feeder
1. Pull out the drawer.
2. Lift out the steam feeder.
3. Fill the steam feeder just to the filter screen.
Steam
Feeder
4. Place the steam feeder in the drawer; then push in the
drawer until it clicks into place.
NOTE
be filled with water up to the MAX line. If not, the will
be displayed. Make sure that the steam feeder is filled
with water or the drawer is fully closed. Turn the dryer
off then restart the Steam Cycle.
Drawer
foreign substances, rinse agents, or detergents.
is empty.
the steam generator will not work.
will be overflow.
and the drawer before starting the dryer.
WARNING
can cause serious injury or death.
follow this warning can cause serious injury or death.
Tap Water
ONLY
Failure to follow this warning
Failure to