Worx AXIS WX550 Manual Original página 11

a standard test method and may be used for comparing
one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in which
the tool is used especially what kind of workpiece is
processed dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is 2 saws in 1 tool with rep saw and jig saw
function, intended for sawing wood, plastic, metal and
building materials while resting firmly on the workpiece.
It is suitable for straight and curved cuts.
ASSEMBLY AND
OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
20V Li-Ion multi-purpose saw
Charging the battery pack
Installing the battery pack
Working mode adjustment
Position I worked as a jigsaw.
Position II worked as a
reciprocating saw.
NOTE: Select the blade best
suitable for the working mode
for better cutting performance
(special reciprocating saw blade
not included).
keep hands away from the hinge
when changing positions.
• To avoid tool being turned on
accidentally, make sure keep your
hands away from the lock-off
button.
• Before operation, make sure the
pivot release button is locked into
position.
ASSEMBLY
Replacing the saw blade
When using jig saw mode, the
blade teeth face outward as shown
in Fig. D1; while in rep saw mode,
the blade teeth should face as
shown in Fig. D3.
button to prevent switch actuation
before making any adjustments or
removing or installing attachments
or accessories.
OPERATION
result in personal injury.
Switching On and Off
NOTE: For safety reasons the On/
Off switch of the machine cannot
be locked; it must remain pressed
during the entire operation.
Pendulum Function
FIGURE
See Fig. A1
WARNING!
• To avoid being pinched,
CAUTION: Keep your hands
away from the lock-off
WARNING! Burn hazard. Do not touch the blade
immediately after use. Contact with the blade may
See Fig. A2
See Fig. A3
See Fig. B1-C4
11
See Fig. D1-D3
See Fig. E
See Fig. F1, F2
EN