Idiomas disponibles
Idiomas disponibles
How To Install
The Speed Control
Rod
1. Put the speed select lever to the
NEUTRAL position.
2. Attach the ball joint, located on the
bottom end of the speed control
rod, to the shift yoke assembly.
See Figure 9. The fasteners
are at-
tached to the ball joint at the
factory.
3. The length ot the ball joint and
speed control
rod have been pre-
adjusted at the factory. If an adjust-
ment is required, loosen the nut.
Remove the fasteners
to discon-
nect the ball joint from the shift
yoke assembly.
To lengthen or
shorten the speed control
rod, turn
the adapter to obtain the correct
length.
4. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Speed Select
Lever
Figure 8
ntrol
Shi
Assembly
Fasteners
Ball Joint
Figure 9
How To Assemble
The Chute Deflector
1. Remove the carriage bolt. See
Figure 10.
4.
2. Raise the chute deflector into op-
erating position.
5.
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
Fasten with washer and Iocknut.
Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
Chute
Deflector
Operating Position j._
\
Carriage_
Bolt
F-021073L
Flang_
Washer
Nut _
1o
Figure 10
