Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Plug the power pack into the outlet and turn the
power pack on (refer to operating instructions below).
Connect the light fixtures to the low-voltage cable (not
included) using fixture connectors, and test the system
before finalizing installation. Once testing is completed
and the system is operational, the cable may be covered
with landscape material (mulch, rock, etc.) or buried up to
6 in. deep.
Note: If the first light connection does not result in the
light turning on, refer to the troubleshooting section
on page 7. When the power pack (A) is on, an
audible hum may be heard. This is normal and
does not affect the performance of the power
pack (A).
7. Mount the power pack (A) to the wall by hanging the
power pack (A) on the Phillips screws (BB) by means
of the keyhole slots located on the back.
OPERATING INSTRUCTIONS
1. After properly installing the power pack (A), turn on the
electrical source. There are two buttons for operation.
By pressing either button, it will turn to another working
mode. Push either button repeatedly to scroll through
different selections.
"0"--0N (lights stay on until manually turned off).
"A" --AU TO (lights turn on at dusk and off at dawn.)
"1" - "9" -- TIMING (lights turn on at dusk and off after
the selected number of hours.)
6
ll
Hour
2
2 Hour
:1
3 Hour
1.4
4 Hour
5
5 Hour
1i
6 Hour
1
7 Hour
B
8 Hour
9
9 Hour
-0
PHOTO EYE
A
Auto On/Off HDusk-to-DawnH
1C1
Manual On/Off
Lowes. co m/po rtfol io
