Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Recommended installation configurations for each
output terminal:
Combined Wattage of all
Recommended Cable Gauge Using 12V Recommended Cable Length
fixtures
Less than 200W
14
12
4. Loosen the term ina I screws located on the bottom of the
power pack (A) and insert one of the pre-stripped wires
under the terminal clamping plate and securely tighten
the terminal screw. Repeat this process for the other side
of the wire, inserting it into the second wire terminal.
CAUTION: To reduce the risk of fire, electrical shock or
damage to the power pack (A), ensure there is
no wire insulation under the terminal clamping
plate and the screws connecting the cable to
the power pack terminals are securely
tightened.
5. Lay a length of low-voltage cable in the general area
where the lights are to be installed. Distribute light
fixtures (not included) as evenly as possible along the
low-voltage cable.
Note:
The first fixture should be a minimum of 10ft.
away from the power pack (A).
5
Less than 1 00 ft
Less than 200 ft
•
10ft
0
\
• •
Lowes.com/portfolio
