Idiomas disponibles
Idiomas disponibles
A
SAFETY INFORMATION
• DO NOT mount power pack on wood decks, indoors or in an enclosed area such as garages or
crawl spaces.
• DO NOT repair or tamper with cord or plug.
• DO NOT use extension cords.
• DO NOT submerge the power pack in water.
• DO NOT connect two or more power packs together.
• DO NOT use the power pack with a dimmer switch.
• DO NOT install the power pack within 10ft. of a pool, spa or fountain.
• Power pack MUST be mounted to a structure or a power pack stand in an upright position. DO NOT
lay the power pack on the ground after connecting it to a circuit.
• DO NOT bury the connectors or cables at depth greater than 6 in.
• DO NOT exceed the maximum wattage of the power pack capacity (200 watts).
• ONLY plug the power pack cord into a covered 120-volt Class A Type GFCI (ground fault circuit
interrupter) receptacle with a hooded flush type cover plate marked "WET LOCATION".
CAUTION
The device is a certified component for landscape lighting systems in which the suitability of the
combination shall be determined by UL or other inspection authorities having jurisdiction.
CALCULATING LIGHTING CAPACITY
This power pack has a 200-watt circuit that powers up to 200 watts of light. To determine
the maximum number of fixtures that can be safely connected to this power pack, add the individual
wattage of all the fixtures. The total wattage of the fixtures must not exceed 200 watts output capacity.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: Reorient or
relocate the receiving antenna; Increase the separation between the equipment and receiver;
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected; Consult the dealer or an experienced radio/TV technician for help.
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Phillips Screwdriver, Drill, 3/16 in. Drill Bit, and Wire
Strippers.
Lowes. co m/po rtfol io
3
