Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
TRIMMER
Problems
Battery indicator LED
flashing
Red error LED flashing
The product does not start
Trimmer runs intermittently
Excessive vibrations/ noise.
BATTERY
Problems
Error LED lit
TECHNICAL DATA
Type Designation: KC200 KC200.X (200- designation of machinery, representative of cordless hedge
trimmer)
Voltage
Cutting speed
Blade length
Tooth spacing
Degree of protection
Machine Weight (Bare tool)
Possible Causes
Low battery voltage.
Overload.
Temperature issue.
Other problems
Deris in the battery
connectors.
Other problems
The battery is not fully
inserted to the machine.
Potential electrical issue.
Cutting attachment issue.
Machine defective.
Possible Causes
The battery is discharged
Temperature issue.
Others
Corrective Action
Charge the battery.
The cutting attachment is jammed,
deactivate the product and then lower
machine for remove.
Remove the battery.
Clean the cutting attachment from
unwanted materials.
Let the product cool down.
Contact Service Agent
Clean the battery connectors with
compressed air or a soft brush.
Contact Service Agent.
Insert the battery fully.
Contact Service Agent.
Replace cutting attachment.
Contact Service Agent.
Corrective Action
Charge the battery. If battery failed to
charge, contact your Service Agent.
Use the battery in surroundings where
temperatures are between 23°F to 113°F
(-5°C and 45°C) for charge; -4°F to 113°F
(-20°C to 45°C) for discharge.
Contact your Service Agent.
KC200 KC200.X**
60 V
MAX ***
2800/3200 SPM
25'' (63 cm)
1.5 inch (38 mm)
IPX4
8.8 lbs (4.0 kg)
EN
13
