Idiomas disponibles
Idiomas disponibles
Installation (continued)
6
Connecting supply lines
CAUTION: Ensure the supply lines do not kink, twist or
bend into a "V" or "L" shape during installation. Do not use
if there are visible signs of damage.
□
Use two adjustable wrenches to connect and
tighten the supply lines to the supply valves.
□
Connect the red supply line to the hot water
supply valve.
□
Connect the blue supply line to the cold water
supply valve.
RED LINE
1
HOT
COLD
2
Removing the quick connector
CAUTION: Use caution when removing the quick
connector hose to prevent cutting your hands.
□
If it is necessary to remove the quick
connector (F), push the quick connector
housing up, hold the housing together
and pull down.
BLUE LINE
1
2
Operation
1
Checking for leaks
□
Detach the pull-down spray (B) from the pull-
down spray hose (K). Hold the pull-down spray
hose (K) firm to prevent it from retracting into the
faucet body (A).
□
Ensure the handle is in the off position. Turn the
hot and cold water supplies on and check all
connections for leaks. If leaks are discovered,
check the connections to ensure they are tight
and properly secured.
□
Lift the handle to allow the water to run for
approximately one minute. This flushes away any
debris that could damage the internal parts.
□
Turn the water off and reattach the pull-down
spray (B).
A
K
B
1
7
Please contact 1-855-HD-GLACIER for further assistance.
2
3
HOMEDEPOT.COM/GLACIERBAY
