Agitator Cleaning; Replacing Belt - Sears Kenmore 116.33728 Manual Del Propietário

Electrical ShockOr Personallnjury
Hazard
Disconnectelectrical supply before
servicing or cleaningthe unit. Failure
to do so could result in electrical
shock or personalinjury from clean-
er or agitatorsuddenlystarting.
To clean agitator turn vacuum over, cut off
any carpet pile and lint entangled around
agitator with a pair of scissors in the
slots provided. Remove hair, string, lint
and other debris from the agitator.
Electrical Shock And Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
II
Place CARPET/FLOOR selector in the
BARE FLOOR position.
CAUTION
BELT, MOTOR SHAFT
AND PULLEY MAY BE HOT!
Make sure the vacuum has com-
pletely cooled prior to replacing belt.
Replace belt whenever a burning rubber
smell caused by excessive slippage occurs.
Press-_
Here
Cover
To remove the belt cover, depress the tab
and rotate off. Remove worn or broken belt.
17
Loop new
belt around Mo
the motor Shaft
shaft. Hold
the inside of Belt-
the belt
against the Pulley
top of the
large pulley
and rotate
the pulley clockwise until the belt is
complete(y on the pulley.
Here
Cover
Rotate the pulley and the motor shaft to
ensure that belt is not twisted or pinched.
Note: See PARTS AND FEATURES for
belt number.
Reinstall belt cover by placing tabs in
nozzle and rotating cover into position.
Securely snap into place.
DO NOT operate cleaner without belt
cover in place.