cecotec BOLERO FLUX PM Manual De Instrucciones página 32

ENGLISH
Cleaning method
1. Immerse the aluminium filters in hot water (40-50 °C), add neutral detergent and let them
soak for 2 to 3 minutes. Protect yourself with gloves and clean the filters with a soft brush
or scouring pad. Do not apply too much force, as filters are very delicate and can be easily
damaged.
2. If you wish, you can also wash the filters in the dishwasher at a temperature of approx.
60 °C.
Cleaning
- Always switch off the power supply before cleaning or performing any maintenance work
on the kitchen hood.
- To prevent the outer surface of the kitchen hood from deteriorating over time, it is
recommended that it be cleaned with hot water and a neutral (non-corrosive) detergent
approximately every two months.
- Do not use abrasive detergents. Otherwise, the surface of the kitchen hood may be
damaged.
- Keep the motor and other parts away from water, as water may damage the appliance.
Carbon filter
- The carbon filter must not be exposed to heat.
- This type of filter has activated carbon and purifies air and absorbs cooking odours.
The activated carbon becomes saturated after a period of time, which will reduce the
adsorption capacity of the filter. The carbon filter cannot be washed nor cleaned in any
way.
- When the kitchen hood is used regularly, the activated carbon filter should be replaced
according to the frequency of use. If frying more frequently, then change the carbon filter
more frequently.
1. Remove the aluminium filters.
2. The carbon filters are located on both sides of the motor. Turn the filters, until they
are firmly in place.
To replace the carbon filter, proceed in reverse order. Fig. 10
3.
Replacing the light bulb/lamp
Please note:
- The light bulb must be replaced by the official Cecotec Technical Support Service or
similarly qualified technicians.
- Always disconnect the power supply before performing any operation on the appliance.
When handling the bulb, make sure that it has cooled down completely before any direct
contact with your hands.
- When handling the bulbs, hold them with a cloth or gloves to prevent sweat from coming
into contact with the bulb, as this may reduce the bulb life.
62
Bolero Flux PM 603500 Inox B / PM 903500 Inox B
Note:
- Before changing the light bulb, make sure that the appliance is switched off and unplugged.
- Protect yourself from danger when changing the light bulb, e.g., by wearing gloves.
6. TROUBLESHOOTING
Problem Cause
The kitchen hood is obstructed.
The light is on, but the
The condenser is damaged.
motor does not work
Motor is jammed or bearing
damaged.
Motor is burnt or gives off a bad
smell.
In addition to the above, check the following:
Neither the light bulb nor
the motor works
The light bulb has blown.
Power cable is loose.
Grease falls out of the The filters are very dirty.
aluminium filters
The kitchen hood The fan is damaged, causing the
vibrates kitchen hood to vibrate when
extracting air.
The engine is not securely
fastened.
The kitchen hood is not securely
fastened.
ENGLISH
Solution
Remove what is obstructing
the hood.
Replace the condenser.
Replace the motor.
Replace the motor.
Replace the light bulb.
Connect the cables according
to the wiring diagram.
Clean or replace the
aluminium filters
immediately.
Replace the fan.
Fix the engine correctly.
Fix the kitchen hood
correctly.
Bolero Flux PM 603500 Inox B / PM 903500 Inox B
63