Idiomas disponibles
Idiomas disponibles
Installation instructions
FEED WATER SUPPLY
Check
and comply
with local plumbing
codes as you
plan, then
install
a cold feed water
supply
fitting.
A. PREFERRED INSTALLATION
Utilizing
existing
kitchen
sink water
supply
valve
(A) and removable
faucet
tubing
(B).
1.
Refer to illustration
below
to complete
assembly
depending
on supply
valve
size (A).
Close the cold water
supply
valve
(A)
under
the sink.
.
3.
Unscrew
the flexible
tubing
line (B) from
the supply
valve
(A) that connects
to the
COLD water
riser.
NOTE:
For rigid
pipe,
see C. Optional
Installation
on page
10.
Note Adapter
(C) orientation:
3/8-inch
installation--Rounded
end of adapter
(C) connects
to supply
valve
(A).
1/2-inch
installation--Rounded
end of adapter
(C) connects
to coupling
(D), then to existing
faucet
tubing
(B).
For 3/8" Plumbing
For 1/2" Plumbing
(B) Faucet
tubing line (not
ded)
D)
piing
(c)
@
Adapter
--_/'!__
(I) Nut
(G)
Gasket
[L_,_
"_
_
(F) Inlet valve .
_Q'_
(G) Gasket
\
(A) Cold water
supply
valve
(not included)
(B) Faucet
tubing line
cluded)
D)
upling
_)
Gasket
@_A
d(C_ter
\
(A) Cold water
supply
valve
(not included)
4.
Assemble
adapter
(C) and coupling
(D)
as shown
in illustration
at left, per your
configuration.
Ensure
that the gasket
(G)
is in place before
final
assembly.
Start
installation
by hand,
then
finish
tightening
with
adjustable
wrench.
Be careful
not
to overtighten
or cross thread
as damage
to threads
may occur.
5.
Hand
tighten
assembled
adapter
(C)
onto
supply
valve
(A) for the proper
size
installation.
Be sure gasket
(G) is in place
before
final
assembly.
Start
installation
by hand,
then finish
tightening
with
an
adjustable
wrench.
Be careful
not to
overtighten
or cross thread
as damage
to threads
may occur.
6.
Reconnect
faucet
tubing
line (B) to top
of adapter
(C).
NOTE:
If inlet
valve
(F) is to be removed
for installation,
refer to E. Removal
and
Reinstallation
of Inlet Valve on page 11.
7.
Cut wire
ties on tubing
coils,
using
care
not to damage
tubes
or parts if using
a
utility
knife.
8.
Remove
the 1/2" nut (I) and ferrule
(H)
from
end of inlet
valve.
Using
the yellow
banded
tubing
provided,
place the nut (I)
and ferrule
(H) onto
the tubing
and install
onto
inlet valve
(F) as shown
at left.
Tighten
with
adjustable
wrench.
Be
careful
not to overtighten
or cross thread
as damage
to threads
may occur.
NOTE: Inspect
the ends of the tubing
prior
to installation
to be sure there
are no
imperfections
and that the end of the tubing
is cut square.
It may
be necessary
to cut
the tubing
again.
9
