Installation instructions
REVERSE OSMOSIS ASSEMBLY
MOUNTING
SYSTEM
INSTALLATION
Choose
a location
under
the sink to mount
the system.
Location
should
be easily
accessible,
with
adequate
clearance
between
the bottom
of the filter
cartridges
and the
floor
or bottom
of the cabinet
for removal
of filter
cartridges.
Allow
enough
space on
either
side of the system
for the tubing
connections.
1.
Remove
the prefilter
and postfilter
cartridges.
To remove
To remove
Prefilter
_
_
Postfilter
2.
Remove
the assembly
cover
by unlocking
the four tabs on the cover from the system.
3.
Use a flat-head
screwdriver
to work
from
left to right
from
the underside
of the
system.
.
Screwdriver
positioning
Use the icons on the bottom
of the
system
for screwdriver
positioning.
I
System
opening
J
//Tab
1
Screwdriver
8
.
Hold
the Reverse
Osmosis
assembly
up to
the wall
surface
where
you wish
to install
it. Mark location
for screws.
There
should
be a minimum
of 17 inches
from
the
marks
to the bottom
of the cabinet
floor.
Screw locations
A,,,^,
,-,-,,-,R,
JULIL,/-IUIIUI_I:
Do not get dirt or
debris inside the assembly
area. Use only to
mark mounting
hole locations.
6.
Install
screws
to the wall, leaving
a 3/16-
inch clearance
between
the head of the
screw
and wall
(drill pilot
holes
if needed).
.
3/16'_
Screws
crew
Wall
Hang
the Reverse
Osmosis
assembly
on
the screws.
Tighten
or loosen
the screws
as desired
until
the system
is secure
on
the wall.
8.
To install
the
cover,
line up
the front
tabs on the
cover with
the
openings
in the system.
9.
Snap the cover
in place; the
tabs will
flex,
allowing
the
cover
to snap
in place.
10. Remove
the
membrane
cartridge.
Membrane
__
To remove