Idiomas disponibles
Idiomas disponibles
EN
10.3 USE THE SAFETY VALVE
7
1. If the jack is suddenly out of power and the pressure
rod can't come down, remove the head of safety
valve.
2. Loose the safety valve with the hex wrench till the
pressure rod falls to the prior position.
3. Then tightening it.
11
MAINTENANCE
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
11.1 GENERAL MAINTENANCE
•
This product does not require oil change in lifetime.
•
Jacks shall be maintained and repaired in
accordance with the manufacturer's instructions.
Such maintenance and repair shall be carried out
by qualified persons.
•
No modifications shall be carried out which
adversely affect the compliance of the jack with this
standard.
•
Keep clean the machine surface timely. Avoid using
solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of
commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
•
Before each use, running the machine idle to make
sure that all function are in order.
English (Original Instructions)
12
WARNING
12
TROUBLESHOOTING
Problem
Possible cause Solution
Jack will not
The on /off but-
work.
ton is defective.
Inspect whether
the ON/OFF
switch is adjus-
ted to the rele-
vant function po-
sition.
The battery ca-
pacity is low.
The pressure rod
Inspect whether
will not rise.
the ON/OFF
switch is adjus-
ted to the rele-
vant function po-
sition.
Check whether
the lowest tem-
perature is within
the range of suit-
able temperature
for this product.
Not using for
long time maybe
cause the oil is
not smooth.
The pressure rod
Inspect whether
will not lower.
the ON/OFF
(Blockage oc-
switch is adjus-
curs)
ted to the rele-
vant function po-
sition.
Not using for
long time maybe
cause the oil is
not smooth.
* If you cannot find the solution to these problems, go to
the service center.
13
TECHNICAL DATA
Voltage
Max loading car weight
10
Contact the serv-
ice center.
If the power
switch is in the
position of "O",
pls adjust the
switch to" | ".
Charge the bat-
tery pack.
If the power
switch is in the
position of "O",
pls adjust the
switch to" | ".
If not, please
preheating the
jack first, making
the hydraulic oil
thaw, then using
it.
Please first press
the bottom of di-
rection switch for
starting one mi-
nute, then press
the top of this
switch.
If the power
switch is in the
position of "O",
pls adjust the
switch to" | ".
Please first press
the top of direc-
tion switch for
starting one mi-
nute, then press
the bottom of this
switch.
24 V
3 Ton
