GreenWorks G24JACK Manual Del Operador página 5

Ocultar thumbs Ver también para G24JACK:
Idiomas disponibles

Idiomas disponibles

EN
repair facility, and any defective parts, decals,
or safety labels or signs shall be replaced with
manufacturer's or supplier's specified parts. A
list of authorized repair facilities should be available
from the manufacturer or supplier.
2.6
SERVICE
Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
2.7
SAFETY WARNINGS FOR JACK
The user shall work in accordance with the
instruction handbook.
The material of the cover is plastic, which is easy to
break, please handle it with care when using. Then
if carrying it, please with the handle, NOT lifting the
pressure rod.
Do not overhaul the machine to avoid destroying the
machine and lose the right of Guarantee.
Do not work for long time, when not using, please
cut off the power.
Avoid the machine dropping into the water and using
in the bad condition.
Take notice of the smooth floor and loading capacity
when using, also pay attention to finding the exact
loading position of the car before the operation of
lifting.
Do not overload when using the machine. Make
sure to stay upright at the same time as the vehicle
being lifted and do not tilt it.
Make sure the car is parked on one side and the
engine hood and doors are closed before using.
It is necessary that the operator can watch the lifting
device and the load during all movements.
It is not allowed to work under the raised load until it
is secured by suitable means.
Only operator provided with all necessary
information about training can operate the machine.
The machine is powered by hydraulic oil. Please
keep the environment well ventilated. Avoid doing it
in the environment of high temperature and rather
low temperature, while the suitable temperature
should be from -20˚C to 50˚C.
Do not throw the machine directly into the dustbin if
it is out of lifetime or during decommissioning, the oil
or other material may pollute environment.
Take care to prevent ice and snow interfering with
the operation of the machine.
The machine should always be used on level
ground with an inclination not exceeding 5°.
English (Original Instructions)
Service and maintenance actions may be carried
out only with disconnection from energy Supplies.
Even all safety requirement are observed, residual
risk may still exist, any of the body part is prohibited
to be under a raised car to avoid crushing hazard.
SAVE THESE INSTRUCTIONS.
3
SYMBOLS ON THE MACHINE
You can use below symbols on the machine.
Please study them and learn their definitions. Correct
interpretation of these symbols let you operate the tool
better and safer.
Symbol
Explanation
Safety Alert
Indicates a potential personal injury
hazard.
Read Operator's Manual
To reduce the risk of injury, user must
read and understand operator's man-
ual before using this product.
Eye Protection
Always wear eye protection with side
shields marked to comply with ANSI
Z87.1.
Wear eye protection
Wear ear protection when operating
this equipment.
Wet Conditions Alert
Do not expose to rain or use in damp
locations.
Recycle Symbols
This product uses nickel-cadmium
(Ni-Cd) and lithium-ion (Li-ion) batter-
ies. Local, state or federal laws may
prohibit disposal of batteries in ordi-
nary trash. Consult your local waste
authority for information regarding
available recycling and/or disposal
options.
Volts
V
Voltage
Direct Current
Type or a characteristic of current
6
loading

Este manual también es adecuado para:

Jkg301