Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
WARNING
Only perform the steps described within these instructions! All further inspection, maintenance and
Gloves and appropriate protective clothing must be worn when performing these instructions.
PROBLEM
Mower fails to operate.
Motor starts and stops
Immediately.
Garden product functions
intermittently.
Lawnmower leaves ragged cut.
POSSIBLE CAUSE
Possible clogging.
The battery is not fully charged. Charge the battery.
The battery is not inserted
(properly).
The grass is too long.
The battery is too hot/cold.
The isolator key is not inserted
correctly/fully.
There is a short delay in the
motor starting after engaging
the switch lever.
The battery is not fully charged. Charge the battery.
The isolator key is not inserted
correctly/fully.
The battery is not inserted
(properly).
The battery is too hot/cold.
Motor protector has activated.
Height of cut is too low.
Cutting blade is blunt.
28
SOLUTION
Check underneath the mower
and clear as necessary (always
wear gardening gloves).
Ensure the battery is correctly
inserted.
Increase the height of cut and
tilt garden product to reduce the
starting load.
Allow the battery to cool/warm
to room temperature.
Fit the key correctly.
This is normal. Hold the switch
lever for 1-3 secs to start the
motor.
Fit the key correctly.
Ensure the battery is correctly
inserted.
Allow the battery to cool/warm
to room temperature.
Allow the motor to cool and
increase the height of cut.
Increase the height of cut.
Replace the blade.
