Sony PlayStation 5 Guía De Seguridad página 7

Remove and attach covers
Remove the covers when performing maintenance on your console, or when installing
an M�2 SSD or disc drive�
Safety warnings
Before removing or attaching the covers, please read the following safety precautions�
Caution
• Keep out of reach of young children� Young children may swallow small parts which
may inflict injury�
• After you have turned off your PS5 console and unplugged the AC power cord and
cables, wait for your console to cool down before removing and attaching the
covers� The main unit of your PS5 console may still be hot immediately after use,
and continued handling of your console may cause burns�
• Be careful not to pinch your fingers in the gaps between parts, and not to hurt your
hands and fingers on the corner of parts�
• When turning on your console, make sure the covers are installed correctly� If the
covers are not installed correctly, it may cause the main unit to overheat�
Remove and attach covers
Place your console on a soft cloth spread over a flat surface before removing or
attaching the covers�
Illustrations show the console with disc drive installed�
• Each cover has different shapes�
To ensure you attach the cover in the correct
position, use the / / / marks on the inside
of the cover as a guide (see illustration on the
right)�
• All covers can be removed and attached in the
same way�
1
Go to the control center and select Power
The screen goes blank, the power indicator flashes white, and then turns off�
2
Remove the AC power cord and cables, and then wait for the PS5
console to cool down.
The main unit of your console is hot immediately after use�
3
4
5
cover cover
6
cover cover
> Turn Off PS5.
Place the console with the bottom facing up and the front side facing
you, and then remove the feet.
Remove the cover.
Slightly lift the cover away from the console to detach its clips and remove it�
Attach the cover.
Align the cover's clips with the corresponding holes on the console and push in until
you hear a "click"�
Attach the feet, connect the AC power cord and cables, and then turn
on the power.
Clips
EN
7