Mechanical Installation - Pentair MAGICSTREAM Guia De Instalacion

This section describes how to install the MagicStream® Laminar.

Mechanical Installation

1. Dig a hole measuring 60cm deep and 60cm square and place the deck housing in it. This will
allow enough room to connect the supply piping and electrical conduit.
2. Solvent weld the conduit and the drain and supply piping to the deck housing.
3. Anchor the deck housing so that the top of the housing cover collar is at the level of the
finished deck (Figure 1). The adjustable collar should be angled so that it will align flush
with the finished deck surface. Once you have made the final adjustments to the collar's
angle, glue the collar to the deck housing.
Housing cover
collar
Figure 1
4. Backfill around the deck housing with gravel to further stabilize the housing during deck
placement. Leave cover in place during deck installation.
The deck housing is made of ABS. Use suitable cement adhesive compatible with ABS and PVC.
Please test before installling.
Installation
Angle the adjustable
housing cover collar so
that it aligns flush with the
finished deck surface, then
glue in place.
Deck housing
12
Section 2
(new pool construction)
Level of finished
deck surface