PROMEBA PS-190 Manual De Instrucciones página 52

USER GUIDE
ELECTRIC CHAIR
06 OPERATION

General functionality of the device.

Cleaning the device (remember that the lack of cleaning can cause the spread of
infections).

Absence of cuts, holes, breaks in the structure, including the belts.

Correct fixing of all nuts, bolts and screws.

Correct attachment of the belts to the chair.

Correct operation of the belt closure.

Condition of moving parts, wheels and belts.

Integrity of the seams.

There are no tubes or metal sheets that show bends or cracks.

The backrest and the seat do not show damage or structural cracks.

The welds are intact, without cracks or breaks.

Wheels are securely fixed, stable and work properly.

Wheels are free of dirt or debris.

Brakes work properly.

Track belts run and have the correct tension for use.

Correct operation of the springs.

Armrests raise and lower correctly.

The transport handles open, close and lock correctly.

Telescopic handles open, close and lock properly.

Presence of all labeling.

Lubrication of moving parts.

The emergency vehicle is equipped with the locking system for the PS-190 chair.
If the above conditions are met, the device may be considered ready for use; otherwise it
must immediately be removed from service and contact the manufacturer.
06.3. Functioning
ARMRESTS
Lower the armrest into the operating position, holding it and pushing it down, until you meet
resistance. To close it again, lift it up to the previous position.
TRANSPORT HANDLES
To close the transport handles, press the red release button and push them down until they
stop. To reopen them, lift them up until they stop.
TELESCOPIC HANDLES
To extend the telescopic grips, stand in front of the device, press the red release buttons and
pull both grips to the forward position. Release the button and slide them forward slightly until
they snap into the locked position.
To fold them, stand in front of the device, press the red release buttons and push both grips
to the rear position. Release the button and slide them back slightly until they snap into the
locked position.
EN
REV. 2023/10
52