Viega 6171.10 Instrucciones De Instalación página 25

Instruction for use Multiplex
GB
B
Components
 Overflow fitting
e Flange cover
i Protective foil
m Profile seal
q Drainage elbow
u Union nut
21
C
Dimensions
Model
6171.10
6171.11
6171.12
D
Assembly
 Mount seal.
d Mount the seal onto the
flange.
g Mount the red protective
cover onto the flange
cover.
j Insert the valve top and
the fastening screw and
tighten using the tool
supplied. The cross-
shaped structure of the
odour trap and the valve
top must be positioned
on top of each other.
 Profile seal
f Fastening flange g Fastening screw h Rotatable collar
j Valve cone
n Wedge seal
r Odour trap
u Bowden wire
22
L
100 - 260 180 - 400
130 - 370 180 - 430
100 - 680 180 - 480
 In the case of steel
bathtubs (max. 3 mm)
also mount the narrow
seal
e Insert the flange into the
overflow fitting.
h Push the rubber sleeve
onto the overflow pipe
until the lower edge is
flush with the edge of
the overflow pipe.
k 560 mm, 725 mm:
Mount overflow pipe.
If necessary, shorten.
The overflow pipe must
be inserted at least 1.5
cm into the odour trap.
 Seal
k Fastening screw l Valve top
o Sliding ring
s Wedge seal
u Overflow pipe
23
H
25
d Seal
p Union nut
t Sliding ring
u Sleeve
24
 Place the flange and the
flange cover together
f Screw in the fastening
screws and tighten per
hand.
i Place the double seal
onto the drain in such
a way that the gap is
positioned over the
connecting pipe.
Pull the edge of the
double seal over the
edge of the drain.
l 1070 mm:
Mount overflow pipes.
If necessary, shorten.
The overflow pipe must
be inserted at least 1.5
cm into the odour trap.