Idiomas disponibles
Idiomas disponibles
Basic connectivity features
Addressing: 1
Transmission speed: 19200
Parity: EVEN
Mode: RTU
Electrical interface: RS-485
Connector type: wiring D0 – D1 – Common
RESET
Manual way to start a reset process is disconnecting power supply, wait at least
30 seconds and power again the electronic control. It is also possible to do re-
motely via Modbus communication using General reset (register number 3).
TECHNICAL DATA
Power supply voltage .........................100-240Vac – 50/60Hz
Protection against electric shock ......Class II
Installation type required ...................Tipo X
Maximum consumption .....................1W
Maximum current ..............................0,01A
Output.................................................0-10Vdc, 2-10Vdc, maximum current 20mA
Relay NC ............................................3A – 250Vac
Relay NO ............................................3A – 250Vac
RF features
Frequency...........................................868.3MHz
Channel band .....................................171KHz
Duty cycle ...........................................<1%
ERP max .............................................-7dBm
Electric connection
All cables used must fulfil with IEC 60.227.
5 x terminals, supply and relay ..........Min. 0,5 mm
5 x terminals, analogue output
and Modbus ........................................Min. 0,25 mm
Note: Same tool can be used for both terminals types
cable / Máx. 1,5 mm² cable
2
M3 screw and 0,5 Nm torque
cable / Máx. 1,0 mm² cable
2
M2 screw and 0,3 Nm torque
EN
13
