Idiomas disponibles
Idiomas disponibles
OPERATION
1. Prior to switching on , turn down the master control MAIN LEVEL for the overall level to
the left stop position to avoid a possible switching on noise.
2. First switch on the connected audio sources, then the PA system. The PWR indicator
light up green. If the LOW indicator light up red during battery operation, the battery
should be recharged.
3. Adjust the MAIN LEVEL control.
4. Adjust the desired volume ratio of the signal sources with the level controls in channel
1-3. Turn the controls of the unused inputs to zero.
5. Optimize the sound of the mixed signal with the tone controls.
6. A reverb effect created via the integrated effect processorcan be added to the microphone
signals of channels1 - 2. To do this, pressdown the REVERB button. In addition, you
should always activate the feedback suppression for the microphone signals with
the KILL FEEDBACK button. This provides crystal clear sound quality even at higher
volumes, without annoying feedback whistling.
7. To improve the audibility of an announcment while a music program is running on
channel 3, activate the talkover function with the CH3 TALKOVER button. Then the level
of channel 3 is automatically attenuated during a microphone announcment.
8. Fine tune the overall volume of the pa system with the MAIN LEVEL control. In case od
overload the red LIMIT indicator light up. If it lights continuously, turn back the MAIN
LEVEL control accordingly.
9. After operation, switch off the PA system First. The PWR indicator goes out. The automatic
charging for the rechargeable battery remains active even if the units is switched off. To
prevent unnecessary power consumption, always disconnect the mains plug from the
socket if the units is not used for a long period.
SETTING BLUETOOTH CONNECTION
1. Press the PLAYER / AUX button to assign the audio player to channel 3.
2. Press the MODE button. The audio player switches to pairing mode, four dots running in
the upper left corner of the screen.
3. Activate the bluetooth function at the source. Pair the devices with each other, the four
dots in the upper leftcorner of the screen stop blinking. Play music at the bluetooth
sources as you normally would and the sound will come out of the PA system.
4. Use the level control in channel 3 to adjust the volume.
5. The bluetooth source may also be operated via the audio player. To interrupt or continue
the playback press the button [
in forward or backward direction.
8
]. Whit the buttnos [
] / [
] you can skip titles
