Extension Cords - Dremel 8220 Instrucciones De Funcionamiento Y Seguridad

1600A01RP1.qxp_8220 4/16/19 3:01 PM Page 18
Preventive maintenance performed by un -
au thorized personnel may result in
misplacing of internal wires and
components which could cause serious
hazard. We recom mend that all tool service
be performed by a Dremel Service Center.
SERVICE MEN: Disconnect tool and/or
charger from power source before servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased
tool performance or significantly shorter
running time between charges then it is time
to replace the battery pack. Failure to do so
can cause the tool to operate improperly or
damage the charger.
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
higher the cord capacity.
Maintenance
To avoid accidents, always disconnect the tool and/or charger from
the power supply before servicing or cleaning.
Service
NO USER SERVICE -
ABLE PARTS INSIDE.

Extension Cords

If an extension cord is
necessary, a cord with
D.C. MOTORS
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six months.
Only a genuine Dremel replacement motor
specially designed for your tool should be
used.
Cleaning
Certain cleaning agents
and solvents damage
plastic parts. Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25 50 100
3-6 18 16 16
6-8 18 16 14
8-10 18 16 14
10-12 16 16 14
12-16 14 12 –
18
Wire Sizes in mm 2
Cord Length in Meters
150
15 30 60 120
14 0.75 0.75 1.5 2.5
12 0.75 1.0 2.5 4.0
12 0.75 1.0 2.5 4.0
12 1.0 2.5 4.0 –
– – – – –