Idiomas disponibles
Idiomas disponibles
MOUNTING THE STRING
TRIMMER GUARD
WARNING:
injury to people, do not operate without
guard in place.
WARNING:
when mounting or replacing the guard.
Be careful of the line-cutting blade on the
guard and protect your hands from being
injured by the blade.
1. Loosen the two bolts in the guard
with the supplied hex key, then
remove the bolts and spring
washers from the guard (Fig. 3a).
2. Lift the trimmer head and face it
downward. Align the two mounting
holes in the guard with the two
assembly holes in the base of the
shaft. Make sure that the internal surface of the guard faces towards the trimmer
head (Fig. 3b).
3. Secure the guard to the shaft using the two bolts and washers (Fig. 3b).
4. Use the supplied hex key to tighten the bolts.
NOTICE:
There are two kinds of guards compatible with this machine. Only the guard
with icon
the brush cutter head. Be careful to choose the correct guard when using the machine.
NOTICE:
The brush cutter guard is not included (part of the EGO kit ABB1203-1, sold
separately).
56-VOLT LITHIUM-ION COMMERCIAL 17.5" STRING TRIMMER — STX4500/STX4500-FC
To reduce the risk of
Always wear gloves
can be used with the string trimmer head and must not be used with
3a
3b
23
