WolfPack M1B-YH8-82X2 Manual De Instrucciones página 20

MAINTENANCE
CAUTION
Before performing any inspection or maintainance work, make sure the tool is switched off and
unplugged.
Replacing the brushes.
The brushes must be inspected regularly and replaced when they are less than 5 mm long.
Keep the brushes clean to ensure that they can move freely inside the brush holders.
Replace both brushes
at the same time. Remove the shaving deflector with a screwdriver, then take off the brush
cover, remove the brushes, install the new brushes and replace the brush cover and shaving
deflector
Replacing the belt
When the belt is worn and prevents the power tool from running property, it must be replaced.
Remove the belt cover by loosening the screws with a screwdriver. Next, remove the belt by
turning it and pulling it out. Mount the new belt by turning it while pushing it in. Note: Make sure
that the belt is properly installed on both pulleys .
When cleaning the tool; use only a brush, never water or other harsh liquids.
Do not dispose electric products in the household waste. According to the European
standard 2012/19/EU for the disposing of electrical equipment (WEEE), it should be taken
to your local waste collection station for recycling.
Figure 5
20