Idiomas disponibles
Idiomas disponibles
21) Warning
-The use of any accessories or attachments other than those recommended in this instruc-
tion manual may present a risk of personal injury.
22) Let your tool be repaired by a qualified person.
-This electric tool is in accordance with the relevant safety requirements.
Repairs should only be carried out by qualified persons using original spare parts, other-
wise this may result in considerable danger to the user.
23) Only use sharp blades.
24) Wait for complete run-down before putting the tool aside.
25) Hearing protection should be worn.
REMOVING AND INSTALLING THE BLADE
CAUTION
Only use the cutting head which is delivered together with original tool or available from the
manufacturer or its authorised service agent.
Always make sure that the tool is switched off and unplugged. Wait for the blades to come to
a full stop before removing or installing the blade. Loosen the three attachment screws with a
socket wrench.
You can remove either the blade alone or both the outer cover and the blade, and then insert
the blade. The new blade must be the same size and weight as the old one; otherwise the spin-
dle will vibrate, the cutting quality will be poor and the tool may be damaged.
Blade spindle
To install the blade, mount it on the guiding rule so that the blade edge touches the guide
piece. Then position the inner cover on the blade so that the curved end touches the rear of the
guiding rule over its entire length and then replace the screws. Tighten the screws of the inner
cover. Once they are tight, mount the blade on the spindle so that the curved end of the inner
cover enters the respective spindle groove. Finally, tighten the three screws with the socket
wrench.
CAUTION.
When mounting the blade on the spindle, the screws must be tight. Otherwise, serious personal
injury may result! Always check that the screws are tight and the blade is properly positioned.
The blade edge and the sole must be parallel. Otherwise, the wood surface will not be flat and
even. Examples of correct and incorrect installation are shown below.
Blade
Outer cover
Screw
Inner cover
17
