Idiomas disponibles
Idiomas disponibles
7. TROUBLESHOOTING
Problems
The gate cannot open or
close normally, and LED
8 does not light.
The gate can open but
cannot close.
The door don't finish the
distance.
Remote control doesn't
work.
Press OPEN, CLOSE
button, the gate is not
moving, motor has noise.
Leakage switch tripped.
Remote control working
distance is too short.
The gate don't finish the
movement.
13
Possible Reasons
1.The control board power is off.
2.Fuse is burned.
3.Control board power wiring with
problem.
1.Photocell wiring with problem.
2.Photocell mounting with problem.
3.Photocell is blocked by objects.
4.Sensitivity of obstacle is too high.
1.The power regulation is low.
2.The door movement isn't smooth.
1.Battery level of the remote control
is low.
2.Remote control learning is not
completed.
The motor is unblocked.
Power supply line short circuit or
motor line short circuit.
1. Transmitter battery is low.
2. May be radio interference.
1.Sensitivity of obstacle is too high.
2.Gate meets obstacle.
Solutions
1.Switch on the power supply of
control board.
2.Check the fuse, change the
fuse if burnt.
3.Re
wiring
according
instructions.
1.If not connect photocell,
please make sure that the IR and
COM short circuit; if connect
infrared sensor, please make
sure the wiring is correct and
the photocell is N.C.
2.Make sure that the photocell
mounting
position
mutually aligned.
3.Remove the obstacle.
4.Reduce the sensitivity of
obstacle.
1.
Increase
the
regulation.
2. Check the distances between
X and Y, and the gate movement
manually is soft.
1.Change the remote control
battery.
2.Re-conduct remote control
learning.
Block the motor with the
blocked keys.
Check wiring.
1.Check
the
transmitter's
battery and replace it if its
necessary.
1.Adjust the VR1, VR2.
2.Remove the obstacle, check
the setup dimensions and the
manual movement off the door
is smooth.
to
can
be
power
