Idiomas disponibles
Idiomas disponibles
2
ASSEMBLY
Section
WARNING
Do not tip machine onto its side or turn machine upside
down during assembly. Machine must be assembled in
an upright position.
WARNING
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
Remove items from the shredder area by removing the
discharge screen.
2.1 ASSEMBLY
2.1.1 INSTALL LEG STAND, AXLE AND
WHEELS
1. Align holes in chipper base (1) with the holes in
axle weldment (2) and the support leg (3). Secure
assembly to chipper base with two 5/16-18 × 2-1/4"
hex head bolts (4) and flange nuts.
2. Secure support leg to the base of the housing body
(5) with two 5/16-18 × 1-3/4" hex head bolts (6), and
flange nuts.
3. Complete by bolting wheels (7) to axle weldment
using two 5/8" × 3" hex head bolts (8).
4. The axle bolts turn into centerlock nuts in the ends of
the axle bar and consequently turn fairly hard. Care
must be taken not to over tighten the bolts or bearing
damage will occur. A properly tightened bolt will allow
minimal side to side movement of the wheel while
allowing the wheel to spin freely.
2.1.2 ATTACH CHIPPER CHUTE HANDLE
Attach handle (9) to chipper chute (10) using two 5/16" ×
3/4" carriage bolts (11) so the head of the bolt is located
on the inside of the chute. Install both bolts through handle
before fastening with 5/16" flange nuts. This handle is to
be attached only to the bottom of part 10.
2.1.3 ATTACH SHREDDER HOPPER
HANDLE
To attach handle (12) to shredder hopper (13), install four
5/16" × 1" hex bolts (14) so the head of the bolt is located
on the inside of the hopper. Secure bolts with 5/16" flange
nuts.
2.1.4 ATTACH SHREDDER HOPPER
1. Install the shredder hopper (13) to the housing body
so the handle is located above the engine and the
opening is toward the chipper chute.
2. Install eight 5/16-18 × 3/4" carriage bolts (15) so the
head of the bolt is located on the inside of the hopper.
Fasten bolts with 5/16" flange nuts.
14
9
10
3 INCH CHIPPER/SHREDDER
13
11
15
5
6
2
8
12
1
7
4
3
5
