Idiomas disponibles
Idiomas disponibles
3. Switching the machine on
Switch the machine on with the mains selector on the wall: the LED A-5 goes on. By pressing the A-1 button for at
least 1 second the machine is switched ON. The A-5 LED goes off and the first leveling of the water begins.
4. Switching the machine off
Switch the machine off by pressing the A-1 button for at least 1 second; all system functions are interrupted, all
LEDs on the control panel go off and the thermometers go off apart from the A-5 LED which goes on (fix) again.
5. Washing program
The dishwasher offers various washing programs which can be selected from the control panel
Program
Short washing cycle (if present)
Normal washing cycle
Long washing cycle
Prolonged washing cycle (if present)
Regeneration program
(if water softener present)
Tank draining (if drain pump is present)
6. Function
After having switched the mains power on by turning the mains selector on the wall the A-5 LED goes on to
indicate that the machine is connected to the mains power. By pressing and holding the ON/OFF button A-1 for at
least 3 seconds the machine starts filling the tank and the boiler and when the correct level has been reached the
heating is activated (the two heating systems are regulated by a changeover switch), the thermometers (where
fitted) on the control panel indicate the temperature and the normal washing cycle LED (A-6) is on.
Wait for some minutes until the temperature on the thermometers A-7 and A-8 (where fitted), correspond to
approximately 85°C for the boiler and approximately 60°C for the tank or verify that the A-9 LED goes on
(where fitted).
At this point the cycle program can be selected by pressing the A-3 button. The start up of the program is not linked
to the tank or boiler temperature. The machine works with automatic washing programs including washing, water
dripping pause, rinsing. The quantity of rinse-aid is regulated through the rinse-aid dispenser unit inside the
machine and is charged through the external bin. The quantity of the detergent may be regulated either by hand or
by an internal or external detergent dispenser.
6.1. Washing
The pump brings the washing water from the tank to the dishes through the pipe system and the upper and lower
washing arms. During the circulation, the washing water passes through a filter system which holds back small
solid particles and protects the pump impeller.
6.2. Water dripping pause
After the washing cycle the machine stops for some seconds to assure that the washing water drips from the
dishes.
6.3. Rinsing
During the last part of the program the washed dishes are rinsed with hot clean water from the boiler to remove the
residues of the washing water. The rinsing water is used to heat up the dishes in order to let them dry as they are
taken out of the machine and it is also used to regenerate the washing water in the tank.
7. Hydraulic rinse-aid dispenser
The hydraulic rinse-aid dispenser is activated during each rinsing phase to inject a certain quantity of rinse-aid into
the
boiler (1cc to 3cc) which is equal to a length of about 8 cm to 24 cm in the feeding tube. The quantity of rinse-aid
can be regulated by turning the regulation screw on the front (E) after having removed the front panel. If the screw
is completely turned in the quantity corresponds to 1cc. When the dispenser is installed for the first time it is
necessary to fill up the feeding tube by repeatedly pressing the regulation screw.
Attention: the minimum feeding pressure, measured at the connection of the water mains of the machine
during final rinsing (flow pressure) must never be below 180 kPa (1,8 bar) even when other machines connected or
taps are opened on the same water supply line. An excessive quantity of rinse-aid may leave bluish strains on the
Istruzioni originali Original instructions Instructions originales Originalanleitungen Instrucciones originales Rev. 3.00 del 14/02/2020 - pag. 23 di 72
Description
For hardly dirty dishes
For normally dirty dishes
For heavily dirty dishes
For small pots or kitchen ware
To regenerate the resins in the water softner
To drain the water from the tank
EN
Lengths
1 min
2 min
3 min
Max. 8 min
21 min
Max. 2 min 20 sec
