Idiomas disponibles
Idiomas disponibles
7.
Adjust spray pattern.
a.
The position of the air cap horns (g) will
determine the spray pattern. Loosen air
cap (h) and rotate horns to achieve
desired pattern. Tighten air cap.
8.
Turn fluid control knob (b) clockwise until it
stops, do not force. This will shut off the fluid flow. NOTE: The fluid or den-
sity of "fan spray" is controlled by fluid control knob (b).
9.
Adjust air pressure to 40 psi at air compressor.
pressure must not exceed 50 psig.
10. Turn air valve control knob (a)
counterclockwise until first thread is flush with
gun body. NOTE: Air flow is controlled by air
valve control knob (a).
knob out until the first thread is past the gun
body. They are under pressure when the gun
is triggered and could leave the gun with
force.
NOTE: Care should be exercised when handling
spray gun to avoid damage to the orifice of the air cap and tip of fluid nozzle.
Damage to these parts results in irregular spray patterns.
11. Depress spray gun trigger (d) and gradually turn the fluid control knob (b)
counterclockwise until desired fluid flow is reached. Trigger gun quickly, on
second on-off to test pattern.
injury.
NOTE: If gun sprays too fast, decrease the air and fluid pressure. If too slow,
increase the pressure. Turn fluid control knob (b) counterclockwise to in-
crease, or clockwise to decrease, the fluid flow. Turn air valve control knob (a)
counterclockwise to increase, or clockwise to decrease, the air flow.
NOTE: When using the internal mix air cap, begin with the same air and fluid
pressure.
Spraying Tips
1.
The stroke is made with a free arm motion, keeping the gun at a right angle
to the surface at all points of the stroke. Arching the stroke will result in
uneven application and excessive over spray at each end of the stroke.
2.
Depress trigger just before reaching the edge of the surface to be sprayed.
Hold the trigger fully depressed and move the gun in one continuous
motion. Release the trigger when the other edge of the surface is reached,
shutting off the fluid flow, but continue motion a few inches until it is
reversed for the return stroke. When the edge of the surface is reached on
the return stroke, depress the trigger fully again and continue across the
surface.
3.
Lap each stroke 50% over the preceding one. Less than 50% will cause
streaks on the finish surface.
Risk of bursting or equipment damage. When the gun is
operated at pressure feed with the cup attached, air
DO NOT turn air valve
control knob or fluid control
NEVER point spray gun at self or any other person.
Accidental discharge of material may result in serious
7- ENG
Horizontal position
Vertical position
first thread flush
a
b
D28262
