Idiomas disponibles
Idiomas disponibles
Convert to Remote Pressure Feed:
1.
Remove the material cup (e) from gun.
2.
Unscrew the shroud retaining sleeve (k) and remove the shroud, shroud
retaining sleeve, fluid tube, and gaskets from the gun. NOTE: To avoid loss
and damage to small parts store them in the material cup and assemble the
shroud to the material cup.
3.
Install thread forming screw (m) (included with spray
gun, part number D26452) into the small pressure port
located on the surface where the shroud gasket seats.
The screw should be tightened until the shoulder
contacts the spray gun body.
4.
The spray gun is now ready to be connected to any
pressure feed tank with a standard 3/8" straight pipe
female connection. See manufacturer's manual for correct procedure.
5.
To operate see steps 2-9 in the "To Use" section to continue.
injury.
Convert to and Use Internal Pressure Feed:
If the material to be sprayed is too heavy for siphon feed or fast application is
desired, convert to the pressure feed setting.
1.
Remove the material cup (e) from gun.
2.
Turn shroud retaining sleeve (k) counterclockwise until the shroud can be
pulled down and is free to rotate (approximately 1/4")
3.
Rotate the shroud until the pressure arrow (l) is facing forward away from
the handle, push shroud up into place and hand tighten the shroud retaining
sleeve.
4.
Fill the material cup (e) 3/4 full.
5.
Attach material cup (e) to the gun securely.
6.
Attach air supply line to 1/4 NPT air inlet (c).
D28262
NEVER point spray gun at self or any other person.
Accidental discharge of material may result in serious
k
6- ENG
m
l
k
