Idiomas disponibles
Idiomas disponibles
pressure by depressing trigger, and disconnect power source. NEVER as-
sume system pressure is zero!
MATERIAL.
This spray gun has a siphon and pressure feed setting. It is set at the factory for
siphon feed application, which makes it ideal for applying light and medium
bodied paints (stain, lacquer) to large size jobs such as complete auto
refinishing. The pressure feed application is used when material being sprayed is
too heavy for siphon feed or fast application is desired. The pressure feed
setting allows the gun to be used with remote paint tank for spraying on larger
painting applications.
DO NOT ATTEMPT TO UNCLOG (BACK FLUSH) SPRAY GUN
BY SQUEEZING TRIGGER WHILE HOLDING FINGER IN
FRONT OF FLUID NOZZLE.
Pressure may vary according to viscosity of material used.
Maximum working pressure of gun is 60 psi. DO NOT
EXCEED PRESSURE LIMIT OF GUN OR ANY OTHER COMPONENT IN
SYSTEM!
Prior to daily operation, make certain that all connections
and fittings are secure. Check hose and all connections for
a weak or worn condition that could render system unsafe. All replacement
components such as hose or fittings must have a working pressure equal
to or greater than system pressure.
Before use
●
Install a moisture
separator/regulator when there
is a possibility moisture will
damage the surface to be
painted. Install the moisture
separator/regulator as close to
the tool as possible.
NOTE: Liquid water occurs
naturally in air lines as a result
of compression. The moisture
exiting near the compressor is
warm and still in a vapor state which allows it to pass through the moisture
separator. The vapor must travel a minimum of 5 to 10 feet to cool down to
a liquid to be removed by the moisture separator. See Illustration.
●
Prior to shipment, this gun was treated with an anticorrosive agent. Before
using this gun make sure that it is carefully flushed with thinner.
D28262
GENERAL INFORMATION
Before disassembly or removal of any part of gun or
attached components, shut off compressor, release
TO AVOID CREATING AN EXPLOSIVE ATMOSPHERE,
WORK ONLY IN WELL-VENTILATED AREAS.
USE OF A NIOSH APPROVED FACE MASK IS
RECOMMENDED TO PREVENT INHALATION OF TOXIC
OPERATION
4- ENG
