Idiomas disponibles
Idiomas disponibles
WARNING
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine
down and away from you.
2. Disconnect the electrically service to the damaged
line or cord before you try to free the blade.
4.1
START THE MACHINE
Figure 6.
1. Pull the safety lock button using your thumb and
then squeeze the trigger.
2. Release the safety lock button.
WARNING
Hold the machine with hands during operation.
4.2
STOP THE MACHINE
Figure 6.
1. Release the trigger to stop the machine.
4.3
ADJUST THE TRIMMER HEAD
ANGLE
Figure 7.
The trimmer head pivots 135° and can be locked into 7
positions within that range.
1. Pull the pivot button and move the head forward or
backward to your desired position.
2. Release the pivot button.
WARNING
The trimmer head should lock securely in place.
4.4
OPERATION TIPS
•
Start by trimming the top of the hedge. Slightly tilt
the tool (up to 15° relative to the line of cut) so that
the blade tips point slightly towards the hedge. This
will cause the blades to cut more effectively. Hold
the tool at the desired angle and move it steadily
along the line of cut. The doublesided blade allows
you to cut in either direction.
•
In order to obtain a very straight cut, stretch a piece
of string along the length of the hedge at the desired
height. Use the string as a guideline, cutting just
above it.
•
In order to obtain flat sides, cut upwards with the
growth. Younger stems move outwards when the
blade cuts downwards, causing shallow patches in
the hedge.
English
•
Take care to avoid any foreign objects. Especially
avoid hard objects such as metal wire and railings,
as these could damage the blades.
•
Regularly oil the blades.
Keep hands away from blade while operating. Contact
with blade will result in serious personal injury.
5
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1
CLEAN THE MACHINE
Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
•
Use a moist cloth with a mild detergent to clean the
machine.
•
Clean all moisture with a soft dry cloth.
•
Use a small brush to clean the air vents.
5.2
LUBRICATE THE BLADE
To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to
remove more dirt.
•
Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
6
STORE THE MACHINE
Clean the machine before storage.
5
WARNING
CAUTION
CAUTION
WARNING
WARNING
NOTE
NOTE
EN
