Downloaded by: pd-oliana on 07-03-2023 10:49 CET
Gas Connection
WARNING: Before starting any work related with gas installation, turn off gas supply. Risk of explosion.
Please operate your oven in dry atmosphere.
1. Fit the clamp to the hose. Push one of the hose until it goes to the end of the pipe.
2. For the sealing control; ensure that the buttons in the control panel are closed, but the gas cylinder is open.
Apply some soap bubbles to the connection. If there is gas leakage, there will be foaming in the soaped area.
3. The oven should be using a well ventilation place and should be
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure that it is at the counter level. Bring it to the counter level
by adjusting the feet if necessary.
6. Do not make gas hose and electrical cable of your oven go through theheated areas, especially through the rear
side of the oven. Do not move gas connected oven. Since the forcing shall loosen the hose, gas leakage may
occur.
7. Please use flexible hose for gas connection.
For LPG connection;
Main Gas Pipe
Gasket
Hose Inlet Connector
Metal Clamp
Lpg Connection Hose
Main Gas Pipe
Gasket
Nut
Natural Gas
Connection Hose
Figure 1
1. For LPG (cylinder) connection, affix metal clamp on the
hose coming from LPG cylinder. Affix an edge of the hose on
hose inlet connector behind the appliance by pushing to end
through heating the hose in boiled water. Afterward, bring
the clamp towards end section of the hose and tighten it with
screwdriver. The gasket and hose inlet connector required for
connection is as the picture shown below.
NOTE: The regulator to be affixed on LPG cylinder should
have 300 mmSS feature.
For natural gas connection;
WARNING: Natural gas connection
should be done by authorized service.
For natural gas connection, place gas-
ket in the nut at the edge of natural gas
connection hose. To install the hose on
main gas pipe, turn the nut. Complete
the connection by making gas leakage
control.
Figure 2
install on flat ground.
