Idiomas disponibles
Idiomas disponibles
INSTALLING/REMOVING BATTERY PACK
See Figure 3.
„ Attach a battery pack to the battery port by aligning the
raised ribs on the battery pack with the grooves in the bat-
tery port, then slide the battery pack onto the battery port.
„ Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
battery port.
„ Latches should snap into place to ensure battery is cor-
rectly connected.
„ If desired, attach additional battery packs.
„ Do not place the waist belt in an area of extreme heat or
cold. It will work best at normal room temperature.
NOTE: Each of the battery ports are numbered on the
adaptor.
„ To remove a battery pack from the waist belt, depress the
latch and pull the battery pack away from the battery port.
WEARING AND ADJUSTING THE SHOULDER
STRAPS
See Figures 4 - 6.
Straps should be adjusted to a comfortable position before
operating a tool.
„ Use the adaptor clip on the back of the adaptor to hook
onto one of the adaptor clip loops on the waist belt as
shown.
„ To adjust shoulder straps and waist belt, slip an arm
through each of the shoulder straps and place them on
your shoulders.
„ Secure the waist strap.
„ Tighten or loosen the adjustable shoulder straps and
adjustable waist straps until the belt power supply rests
comfortably against the small of your back and the shoul-
der straps are secure
„ Secure the excess adjustable waist straps down with the
hook and loop retainer.
OPERATION
INSTALLING THE ADAPTOR INTO A TOOL
See Figure 7.
WARNING:
Always remove adaptor from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing adaptor will prevent accidental
starting that could cause serious personal injury.
To install adaptor:
„ Place the adaptor in the tool. Align raised ribs on adaptor
with grooves in the tool's battery port.
WARNING:
Make sure the latch on the bottom of the adaptor snaps
in place and the adaptor is fully seated and secure in the
tool's battery port before beginning operation. Failure to
securely seat the adaptor could cause the adaptor to fall
out, resulting in serious personal injury.
To remove adaptor:
„ Press and hold the latch at the bottom of the adaptor.
„ Remove adaptor from the tool.
BATTERY FUEL GAUGE
See Figure 8.
To display the amount of charge left in the battery, press
the charge level indicator button. In the event of an error in
discharge, the LEDs will flash the error code for at least 5
seconds.
LED FUNCTIONS
5 — English
CHARGE STATUS
85 - 100%
60 - 85%
35 - 60%
10 - 35%
0 - 10%
