Dreiha ATMOS 2.6 Manual página 12

TURBO button
Under COOL or HEAT mode, press this button to turn to
quick COOL or quick HEAT mode. "
on remote controller. If start this function, the unit will run
at super-high fan speed to cool or heat quickly so that the
ambient tem- perature approaches the preset temperature
as soon as possible.
NOTE:
Fan Speed " " is unavailable for some models,
Fan Speed " " is the same with Fan Speed "
for some models.
Function introduction for
combination buttons
Child lock function
Press "+" and "-" simultaneously to turn on or turn off child
lock function. When child lock function is on, " " icon is
displayed on remote controller. If you operate the remote
controller, the " " icon will blink three times without
sending signal to the unit.
Temperature display switchover function
Under OFF status, press "-" and "MODE" buttons
simultaneously to switch temperature display between ℃
and ℉.
WiFi function
Press "MODE" and "TURBO" button simultaneously to turn
on or turn off WiFi function. When WiFi function is turned
on, the "WiFi" icon will be displayed on remote controller;
Long press "MODE" and "TURBO" buttons simultaneously
for 10s, remote controller will send WiFi reset code and
then the WiFi function will be turned on. WiFi function is
defaulted ON after energization of the remote controller.
NOTE:
This function is only available for some models.
Replacement of batteries in remote
controller
" icon is displayed
1. Press the back side of remote controller marked
"
2. Replace two 7# (AAA 1.5V) dry batteries, and make
3. Reinstall the cover of battery box.
NOTICE:
• During operation, point the remote control signal
sender at the receiving window on indoor unit.
• The distance between signal sender and receiving
window should be no more than 8m, and there
should be no obstacles between them.
• Signal may be interfered easily in the room where
there is flfluorescent lamp or wireless telephone;
remote controller should be close to indoor unit
during operation.
• Replace new batteries of the same model when
replacement is required.
• When you don't use remote controller for a long
time, please take out the batteries.
• If the display on remote controller is fuzzy or there's
no display, please replace batteries.
signal sender
reinstall
remove
Cover of battery box
with " ", as shown in the fig, and then push out
the cover of battery box along the arrow direction.
sure the position of "+" polar and "-" polar are
correct.
battery