OPERATING INSTRUCTIONS
HEATER CONTROL PANEL
WARNING: The Heater must be properly installed before use.
1.
Turn on the power supply to the heater at the main switch panel.
2.
When the heater has power, the red POWER light will turn on.
3.
Pressing the red POWER button will toggle the heater on and off. Upon
pressing this button, the heater and fan will immediately start, and the digital
display will flash for approximately 5 seconds.
a.
If the room temperature is below 65°F, the heater will continue to
run until the room temperature reaches 65°F. Afterward, the heater
will cycle on and off to maintain this temperature.
b.
If the room temperature is above 65°F, the display window will show
65 and flash 5 times, and the heater and fan will stop.
4.
Adjusting Power Level (Mode): While the unit is on, press the MODE button
once. This will activate the power selection mode, and the red light over "L" or
"H" will flash to indicate the current setting. Use the UP or DOWN Arrow
buttons to switch between High and Low power levels. After approximately 5
seconds, the control will be programmed for the selected output.
Note: The unit has an Energy Saving system with a designed ECO program. It
will automatically adjust the power output to low power when the room
temperature is 2°F below the set point temperature to save energy.
5.
Adjusting temperature: While the heater is on, press the MODE button twice.
This will activate the temperature selection mode, and the digital display will
flash with the current setting. Use the UP or DOWN buttons to adjust the
temperature until the desired value is displayed. After 5 seconds, the display
will revert to showing the room temperature.
6.
Setting the timer: This feature allows the heater to operate for a
predetermined time. While the heater is on, press the green MODE button
www.newair.com
EN
15