Idiomas disponibles
Idiomas disponibles
Problem
The product makes
an irregular scratch
pattern.
There are sudden un-
wanted movements
in the product.
The LED indicator
does not change
from red to green.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product for shorter
distances.
For longer distances, lift the product to move it or put the
product on a vehicle.
•
Make sure that the product is in transport position
during transportation. Refer to
page 10 .
•
Be very careful when you move the product
manually or on surfaces with a slope. Small slopes
can result in a strong movement that is not possible
to brake by hand.
•
Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
20
Cause
The diamond tools are incorrectly attached or
attached at different heights on the grinding
discs.
The diamond tools are of mixed types.
The resin tools are mixed or have unwanted
contamination.
The grinding discs are worn or damaged.
The grinding discs are worn or damaged.
The diamond tools are incorrectly attached or
attached at different heights on the grinding
discs.
There is an electrical error in the ignition sys-
tem.
Transportation, storage and disposal
Be careful during
Handle positions on
Solution
Make sure that all diamond tools are installed
correctly and have the same height.
Make sure that all segments are the same
diamond grit and bond. If the diamond seg-
ments are rough, space out the rough dia-
mond segments equally. Operate the product
on an abrasive surface until all segments
have the same height.
Make sure that all resins are the same dia-
mond grit and bond and that there is no con-
tamination. To clean the resin tools, operate
them for a short time on a lightly abrasive
surface
Examine the grinding discs for broken sec-
tions or too much movement.
Examine the grinding discs for damaged
parts and too much movement.
Make sure that all diamond tools are installed
correctly and that all have the same height.
Speak to your Husqvarna service dealer.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
WARNING:
slope, always use a winch. Do not stay
below or near the product.
WARNING:
on steep slopes. Look at the rating plate
on the product for information about the
maximum slope angle.
•
To move the product down a ramp, operate the
product rearward slowly.
•
To move the product up a ramp, operate the product
forward slowly.
Be very careful when you
For ramps with a steep
Do not move the product
1991 - 001 - 02.06.2023
