Preparing The Machine Before Installing The Hoop; Attaching And Removing Embroidery Hoop - Singer XL-420 Manual De Instrucciones

PREPARING THE MACHINE BEFORE
INSTALLING THE HOOP
1. Turn hand wheel counter clockwise (toward you) until the
needle comes to its highest position.
ATTACHING AND REMOVING
EMBROIDERY HOOP
1. Raise presser foot and needle, and push up lever (A) of
embroidery foot with your finger and pass embroidery hoop
under it.
 To remove, pull the hoop forward to slide it out from
underneath the embroidery foot.
2. Slide the hoop onto the embroidery unit from front to back
until it clicks into place.
 To remove, press the release lever and slide the hoop
towards you.
NOTE: Before attaching small hoop or endless hoop, turn on
power switch to move the carriage to embroidering
standby position.
70
1
1
( A )
Carriage
2
Chariot
Carro
Hoop mounting plate
Plaque de montage de cerceau
Placa de montaje de aro
Hoop release lever
Levier de retrait du cerceau.
Palanca de liberación del aro