PRODUCT ASSEMBLY (CONTINUED)
Insert the attachment Shaft Housing into the attachment hub, making certain the power
3.
shaft fits into the square hub socket. If necessary, rotate the attachment back and forth.
The pin on the attachment housing will fit into the notch of the hub rim when in the proper
position.
Tighten the Stand Mixer attachment hub knob clockwise until the attachment is completely
4.
secured to the Stand Mixer.
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
Plug the Stand Mixer into an earthed outlet.
5.
ASSEMBLING THE SIFTER+SCALE ATTACHMENT
To install the Swivel Chute: Lower the Swivel Chute into the Sifter Housing at an angle,
1.
aligning the marks on the Swivel Chute with the marks above the notches on the inside of
the Sifter Housing. Properly installed, Swivel Chute will be seated securely in the Sifter
Housing and will rotate easily.
TIP: Aligning the handle tab on the chute with one of the notches as you lower the Swivel
Chute into the Sifter Housing will help you to line up the marks.
To install the Sifter Assembly: Lower the Sifter into the Sifter Housing at an angle so that
2.
the drive shaft can be inserted into the Sifter Housing. Once the shaft is inserted all the
way, press down on the Sifter, opposite of the shaft, to click it into place.
To install the scale: Place the scale on top of the Sifter Housing with the Digital Scale
3.
display facing away from the Stand Mixer, and slightly left of centre. Twist the scale
counterclockwise until it locks into place.
To install the Ingredient Hopper: Align the Ingredient Valve with the corresponding notch
4.
on the scale, and lower the hopper onto the scale until fully seated.
PRODUCT USAGE
WEIGHING AND SIFTING INGREDIENTS
Press
(On/Off), then press
1.
Before adding ingredients to the hopper, be sure the Ingredient Valve is in the closed
2.
position and Swivel Chute is pointed into the mixer bowl or an appropriate container.
NOTE: If desired, the scale and hopper can sit on the countertop, and ingredients can be
added until the target weight is achieved. The full scale and hopper can then be installed
onto the attachment.
WARNING
Electrical Shock Hazard
(Tare) until the display reads 0.
5
