Idiomas disponibles
Idiomas disponibles
English
STANDARD ACCESSORIES
Fig. 3
WARNING:
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
The machine may be bolted (2 bolts) down to a level location using the bolt holes in the
base.
2. Extension Cord.
Ampere rating
(on nameplate)
Ext. cord length
25 ft
(7.5 m)
50 ft.
(15 m)
100 ft.
(30.5 m)
NOTE: The lower the wire size number, the heavier the wire, and the farther it will carry
current without a voltage drop.
WARNING:
3. Take off the chain.
As the movable part is pulled down by a chain when shipping out, slightly push the
handle down and take off the chain from the handle.
10
2
1 Cut-Off Wheel 14" × 7/64" × 1"(355 × 2.8 × 25.4 mm)
2 Hex. bar wrench
The use of attachment or accessories not recommended in this manual
may be hazardous.
12.1 to 16.0
Wire gauge size
2
A.W.G (mm
)
14 A.W.G
2
(2.0 mm
)
12 A.W.G
2
(3.5 mm
)
Not
recommended
Never connect this unit to an electrical power source until all operating
instructions have been read and understood.
1pc. (Code No.)
(Attached to the main body)
To use the power tool when no suitable power
source is nearby, use an extension cord of
suitable size to ensure safety, and to prevent
power loss and overheating.
Determine from the accompanying table the
required extension cord wire size.
Check power cord and extension cords for loose
or exposed wires and damaged insulation,
before using.
Repair or replace as needed, before using the
power tool.
