Makita DTM51 Manual De Instrucciones página 8

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing application
tool (optional accessory)
WARNING:
• Do not install application tool upside down.
Installing application tool upside down may
damage the tool and cause serious personal
injury.
• Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
CAUTION:
• Be careful when closing the lock lever. The lock
lever may close suddenly and pinch your finger.
• Clean up dust and perform lubrication on the
moving part of the lock lever from time to time.
Otherwise dust may accumulate in the moving
part of the lock lever and hinder its smooth
movement.
• Do not start the tool while the lever opens. The
tool may be damaged.
1. Open the lock lever fully. And remove the holder
bolt.
2
► 1 . Holder bolt 2. Lock lever
2. Put an application tool (optional accessory) on the
tool flange so that the protrusions of the tool flange
fit in the holes in the application tool.
► 1 . Holder bolt 2. Holes in the application tool
3. Protrusions of the tool flange
3. Insert the holder bolt till it stops. And then, return
the lock lever to its original position.
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
To remove the holder bolt, follow the installation proce-
1
dures in reverse.
► 1 . Adapter
8 ENGLISH
2
1
2
3
1
1